Nsi-industries DGM100 Old Series User Manual download pdf

TORK DGM100

DIGITAL TIME SWITCH

SEVEN DAY

READ INSTRUCTIONS CAREFULLY BEFORE SETTING UNIT

FEATURES

Single channel controller

7 day scheduling

Special day scheduling

32 set points

2 second momentary output for use with low voltage

latching relays, mechanically held contactors, electri-

cally (magnetically) held contactors.

Battery back-up uses standard 9 volt non-recharge-

able (not supplied). Lithium averages 450 hours of

power outage; Alkaline averages 175 hours

Manual override to the next scheduled event

Automatic daylight saving - user selectable

Automatic leap year compensation

AM/PM or 24 hour format - user selectable

INSTALLATION

UNIT IS TO BE INSTALLED BY A LICENSED ELECTRICIAN

Unit contains 2 SPDT relays. Left relay will close

for 2 seconds between C & NO when an ON pulse

is scheduled. Right relay will close for 2 seconds

between C & NO when an OFF pulse is scheduled.

NOTE: C & NC of right relay is used to OPEN elec-

trically held contactors.

1. To remove unit from enclosure: Push tab on right

to swing unit to the left and remove.

2. Mount the enclosure at eye level using screws or

other suitable fastening device. Bring supply and

load wires in through bottom or side knockouts.

DO NOT USE TOP.

Input wires to controller must be dedicated i.e. no

other loads connected to the same circuit.

3. Install a standard 9 volt lithium or alkaline battery

(not supplied) by gently squeezing the right side of

the battery cover on the front of the unit and pull

to open. Pull out the battery connector and con-

nect the battery. Reinstall battery cover. Lithium

should be replaced every 3-5 years, Alkaline

every year.

NOTE: Unit can be fully programmed using battery

power only.

4. Reinstall unit by reversing step #1 above and con-

nect wires to unit as per suggested wiring dia-

grams. See illustration on enclosure label.

KEY FUNCTIONS

DAY/MONTH: Press to advance the day in the CLK

mode. Press to advance the Month in the DATE

mode.

HOUR/DATE: Press to set the Hours in the CLK

mode and in the Schedule SET mode. Press to

advance Date in the DATE mode.

MIN/YEAR: Press to set the Minute in the CLK mode

and in the Schedule SET mode. Press to advance

Year in the DATE mode.

OVERRIDE: Press to alter the Load status and/or to

Override scheduled event.

MODE: Press to advance to next mode without

affecting the scheduled memory information.

Sequence is: RUN, CLK, DATE, schedule SET. In

the SET mode, unit automatically reverts to the

RUN mode if no entries are made for 5 minutes.

SP DAY: Press during RUN mode to execute the

“SPECIAL DAY” schedule everyday. LCD will display

D in upper right corner. Pressing SP DAY again will

toggle the unit back to normal 7 day program opera-

tion.

DAY

MONTH

HOUR

DATE

MIN

YEAR

OVER-

RIDE

MODE

DAY

ON/

OFF

ENTER

1 2 3 4 5 6 7

Summary of Contents

Page 1 - SEVEN DAY

TORK DGM100DIGITAL TIME SWITCHSEVEN DAYREAD INSTRUCTIONS CAREFULLY BEFORE SETTING UNITFEATURESSingle channel controller 7 day scheduling Special day

Page 2

TORK DGM100DIGITAL TIME SWITCHSEVEN DAYREAD INSTRUCTIONS CAREFULLY BEFORE SETTING UNITFEATURESSingle channel controller 7 day scheduling Special day

Page 3

ON/OFF: Pressing each time will select ON or OFFpulse. Multiple OFF pulses may be scheduled to can-cel override ON pulses.ENTER: Press to store the di

Page 4

ON/OFF: Pressing each time will select ON or OFFpulse. Multiple OFF pulses may be scheduled to can-cel override ON pulses.ENTER: Press to store the di

Page 5 - REVIEW/MODIFY/ADD/DELETE

Press MONTH key to set present month. Press DATEkey to set today’s date. Press YEAR key to set presentyear. Press ENTER key. Unit now stores present d

Page 6

Press MONTH key to set present month. Press DATEkey to set today’s date. Press YEAR key to set presentyear. Press ENTER key. Unit now stores present d

Page 7 - OVERRIDE

MLI-98(A) TORK®1 GROVE STREET, MT. VERNON, NY 10550 TEL: 914-664-3542FAX: 914-664-5052MODIFY: During the review process, the DAYHOUR, MIN. and ON/OFF